Ultimate Guide to Prepare NSE7_SDW-7.0 with Accurate PDF Questions [Dec 17, 2023]
Pass Fortinet With BootcampPDF Exam Dumps
NEW QUESTION # 32
Refer to the exhibit.
The exhibit shows the BGP configuration on the hub in a hub-and-spoke topology. The administrator wants BGP to advertise prefixes from spokes to other spokes over the IPsec overlays, including additional paths. However, when looking at the spoke routing table, the administrator does not see the prefixes from other spokes and the additional paths.
Based on the exhibit, which three settings must the administrator configure inside each BGP neighbor group so spokes can learn other spokes prefixes and their additional paths? (Choose three.)
- A. Enable soft-reconfiguration
- B. Set adv-additional-path to the number of additional paths to advertise
- C. Set advertisement-interval to the number of additional paths to advertise
- D. Enable route-reflector-client
- E. Set additional-path to send
Answer: B,D,E
NEW QUESTION # 33
Refer to the exhibit.
An administrator is troubleshooting SD-WAN on FortiGate. A device behind branch1_fgt generates traffic to the 10.0.0.0/8 network. The administrator expects the traffic to match SD-WAN rule ID 1 and be routed over T_INET_0_0. However, the traffic is routed over T_INET_1_0.
Based on the output shown in the exhibit, which two reasons can cause the observed behavior? (Choose two.)
- A. The traffic matches a regular policy route configured with T_INET_1_0 as the outgoing device.
- B. T_INET_1_0 has a higher member configuration priority than T_INET_0_0.
- C. T_INET_0_0 does not have a valid route to the destination.
- D. T_INET_1_0 has a lower route priority value (higher priority) than T_INET_0_0.
Answer: A,C
NEW QUESTION # 34
Which components make up the secure SD-WAN solution?
- A. Datacenter, branch offices, and public cloud
- B. Application, antivirus, and URL, and SSL inspection
- C. FortiGate, FortiManager, FortiAnalyzer, and FortiDeploy
- D. Telephone, ISDN, and telecom network.
Answer: C
NEW QUESTION # 35
What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process? (Choose two.)
- A. The FortiGate cloud key has not been added to the FortiGate cloud portal.
- B. The zero-touch provisioning process has completed internally, behind FortiGate.
- C. FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager
- D. A factory reset performed on FortiGate.
- E. FortiGate has obtained a configuration from the platform template in FortiGate cloud.
Answer: A,B
NEW QUESTION # 36
Which diagnostic command can you use to show the member utilization statistics measured by performance SLAs for the last 10 minutes?
- A. diagnose sys sdwan log
- B. diagnose sys sdwan health-check
- C. diagnose sys sdwan sla-log
- D. diagnose sys sdwan intf-sla-log
Answer: C
NEW QUESTION # 37
Refer to the exhibit.
Which are two expected behaviors of the traffic that matches the traffic shaper? (Choose two.)
- A. The traffic shaper limits the combined bandwidth of all connections to a maximum of 5 MB/sec.
- B. The traffic shaper limits the bandwidth of each source IP address to a maximum of 625 KB/sec.
- C. The number of simultaneous connections among all source IP addresses cannot exceed five connections.
- D. The number of simultaneous connections allowed for each source IP address cannot exceed five connections.
Answer: B,D
NEW QUESTION # 38
Refer to the exhibit.
Which two SD-WAN template member settings support the use of FortiManager meta fields? (Choose two.)
- A. Cost
- B. Gateway IP
- C. Priority
- D. Interface member
Answer: B,D
NEW QUESTION # 39
Which CLI command do you use to perform real-time troubleshooting for ADVPN negotiation?
- A. diagnose debug application ike
- B. get ipsec tunnel list
- C. get router info routing-table all
- D. diagnose vpn tunnel list
Answer: A
Explanation:
IKE real-time debug - useful when debugging ADVPN shortcut messages and spoke-to-spoke negotiations.
* diagnose debug console timestamp enable
* diagnose vpn ike log filter clear
* diagnose vpn ike log filter mdst-addr4 <ip.of.hub> <ip.of.spoke>
* diagnose debug application ike -1
* diagnose debug enable
NEW QUESTION # 40
Refer to the exhibits.
Exhibit A
Exhibit B
Exhibit A shows the SD-WAN performance SLA configuration, the SD-WAN rule configuration, and the application IDs of Facebook and YouTube. Exhibit B shows the firewall policy configuration and the underlay zone status.
Based on the exhibits, which two statements are correct about the health and performance of port1 and port2? (Choose two.)
- A. Non-TCP Facebook and YouTube traffic are not used for performance measurement.
- B. FortiGate is unable to measure jitter and packet loss on Facebook and YouTube traffic.
- C. The performance is an average of the metrics measured for Facebook and YouTube traffic passing through the member.
- D. FortiGate identifies the member as dead when there is no Facebook and YouTube traffic passing through the member.
Answer: A,C
Explanation:
Study Guide 7.0, pages 88 - 89.
Study Guide 7.2, pages 103 - 104.
Another comment said "because without using application Control on the firewall policy, SDWAN can't work" but there is a app control "default" defined on config.
NEW QUESTION # 41
Refer to the exhibits.
Exhibit A -
Exhibit B -
Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SD-WAN member status, the routing table, and the performance SLA status.
If port2 is detected dead by FortiGate, what is the expected behavior?
- A. Port2 becomes alive after three successful probes are detected.
- B. The administrator manually restores the static routes for port2, if port2 becomes alive.
- C. FortiGate removes all static routes for port2.
- D. Host 8.8.8.8 is reachable through port1 and port2.
Answer: C
Explanation:
This is due to Update static route is enable which removes the static route entry referencing the interface if the interface is dead
NEW QUESTION # 42
Which three matching traffic criteria are available in SD-WAN rules? (Choose three.)
- A. Source and destination IP address
- B. Type of physical link connection
- C. Internet service database (ISDB) address object
- D. URL categories
- E. Application signatures
Answer: A,C,E
NEW QUESTION # 43
Which are three key routing principles in SD-WAN? (Choose three.)
- A. By default, SD-WAN rules are skipped if the best route to the destination is not an SD-WAN member.
- B. Regular policy routes have precedence over SD-WAN rules.
- C. By default, SD-WAN members are skipped if they do not have a valid route to the destination.
- D. SD-WAN rules have precedence over ISDB routes.
- E. FortiGate performs route lookups for new sessions only.
Answer: A,B,C
NEW QUESTION # 44
Which best describes the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?
- A. Reverse-policy shaping mode
- B. Shared-policy shaping mode
- C. Interface-based shaping mode
- D. Per-IP shaping mode
Answer: C
Explanation:
Explanation
Interface-based shaping goes further, enabling traffic controls based on percentage of the interface bandwidth.
NEW QUESTION # 45
Refer to the exhibit.
The device exchanges routes using IBGP.
Which two statements are correct about the IBGP configuration and routing information on the device? (Choose two.)
- A. Each BGP route is three hops away from the destination.
- B. You can run the get router info routing-table database command to display the additional paths.
- C. ibgp-multipath is disabled.
- D. additional-path is enabled.
Answer: B,D
NEW QUESTION # 46
Which diagnostic command can you use to show the member utilization statistics measured by performance SLAs for the last 10 minutes?
- A. diagnose sys sdwan log
- B. diagnose sys sdwan health-check
- C. diagnose sys sdwan sla-log
- D. diagnose sys sdwan intf-sla-log
Answer: C
Explanation:
SD-WAN 7.2 Study Guide page 321 You can view the stored member metrics by running the diagnose sys sdwan sla-log command. Note that you must include the name of the performance SLA followed by the member configuration index number. To display the SLA logs per interface, you run the diagnose sys sdwan intf-sla-log command.
NEW QUESTION # 47
Which statement is correct about SD-WAN and ADVPN?
- A. SD-WAN can steer traffic to ADVPN shortcuts, established over IPsec overlays, configured as SD-WAN members.
- B. SD-WAN does not monitor the health and performance of ADVPN shortcuts.
- C. You must use IKEv2 on IPsec tunnels.
- D. Routes for ADVPN shortcuts must be manually configured.
Answer: A
NEW QUESTION # 48
Refer to the exhibits.
Which two statements about the IPsec VPN configuration and the status of the IPsec VPN tunnel are true? (Choose two.)
- A. The phase 1 configuration supports the network-overlay setting.
- B. FortiGate facilitated the negotiation of the T_INET_1_0_0 ADVPN shortcut over T_INET_1_0.
- C. FortiGate does not install IPsec static routes for remote protected networks in the routing table.
- D. Dead peer detection is disabled.
Answer: A,C
NEW QUESTION # 49 
Exhibit B -
Exhibit A shows the system interface with the static routes and exhibit B shows the firewall policies on the managed FortiGate.
Based on the FortiGate configuration shown in the exhibits, what issue might you encounter when creating an SD-WAN zone for port1 and port2?
- A. port1 is referenced in a firewall policy.
- B. port1 and port2 are not administratively down.
- C. port1 is assigned a manual IP address.
- D. port2 is referenced in a static route.
Answer: A
NEW QUESTION # 50
......
Fortinet NSE7_SDW-7.0 exam is targeted at experienced network security professionals who are responsible for designing, deploying, and managing SD-WAN solutions using Fortinet products. NSE7_SDW-7.0 exam is ideal for network engineers, security architects, network administrators, and IT managers who are looking to enhance their skills and knowledge in SD-WAN technology and who are seeking to differentiate themselves in a competitive job market.
Latest NSE7_SDW-7.0 Exam Dumps - Valid and Updated Dumps: https://examcollection.bootcamppdf.com/NSE7_SDW-7.0-exam-actual-tests.html